mBus 60 converter is a transparent converter from RS232 to MBus interface. On MBus side it works as MBus master and enable to connect maximum 60 standard MBus receivers (slaves). Additionally thanks to embedded MBus slave input MBus 60 can operate as MBus signal buster. It can be used with all devices equipped with MBus interface like: heating energy meters, electric energy meters, data recorders and many others with MBus interface. mBus 60 can successfully replace PW3, PW20, PW60 Relay M-Bus level converter, any other M-Bus master converter or M-Bus signal buster.
mBus 60 converter is equipped with TX, RX, MBus overload and Power supply LED indicators. There are screw terminal block connectors on Power supply, MBus Master and MBus Slave side and BH10 (10 pins) connector on RS232 side.
Features
RS232 to MBus level conversion
Can operate as MBus signal booster / Repeater
Maximum 60 MBus slaves
Baud Rate: 300 to 19200 bps
RS232 – MBus opto isolation
Over-current and short-circuit protection on the MBus
LED display for power, overload and data transmission
Industrial computer NPE X500 Plus with iMod software, Telemetry Module, ARM11, 700MHz, 512 MB Ram, 4096 MB Flash, Linux 3.6, RTC, 240 byte SRAM, Watch Dog Timer, 1 x RJ-45 10/100 Mbps, 3 x RS-232 / 2 x RS-485, 4 x DI, 4 x DO, 2 x AI, 1 x 1-Wire, 1 x USB 2.0, 1 x SIM CARD slot, LTE, M-Bus, Wi-Fi, Bluetooth, GPS, Zigbee, embedded computer, serial server, IoT, iMod, GPIO, Modbus, MQTT, SNMP